/  
  /  

Animal Feed Forums

Here you can generate a discussion about the daily development of their work, make questions and / or share your experiences.
Last comment: February 3, 2017
(1720) (18)
Typically the target of the feed, what causes of the composition of raw materials created the broilers wet droping?...
Last comment: February 2, 2017
(5) (0)
Typically the target of the feed, what causes of the composition of raw materials created the broilers wet droping?...
Last comment: February 2, 2017
(3) (0)
Typically the target of the feed, what causes of the composition of raw materials created the broilers wet droping?...
Last comment: February 2, 2017
(4) (0)
Last comment: January 27, 2017
(4075) (2)
Last comment: January 26, 2017
(333) (1)
Last comment: January 19, 2017
(12) (0)
How can we select die plate open area or die hole quantity based on our formulation, so that we can increase the capacity and better quality. Our extruder is twin screw. In formula protein % is aroun...
Last comment: January 12, 2017
(78) (2)
How can we select die plate open area or die hole quantity based on our formulation, so that we can increase the capacity and better quality. Our extruder is twin screw. In formula protein % is ar...
Last comment: January 9, 2017
(13) (0)
I need help on extrusion of fish sinking feed .I reach 50:50 of sinking and i need 99 % but i just can not make feed to sink is it from formulation or from adjustments of the extruder....
Last comment: December 27, 2016
(1203) (50)
Algae can be a new feed and feed additive solutions for poultry and swine nutritional applications. Algae has been tested and used as a cattle feed and supplement with good results....
Last comment: December 21, 2016
(5) (0)
Hello I would like to use single screw extruder of aquaculture factory to make pet food I need to know the specific parameters Water / steam / cooking time / drying time My formula Rice 25% Corn ...
Last comment: December 20, 2016
(17) (1)
The use of Expanders on Solvent Extraction Plants has been implemented for several years with a high degree of success. Properly cooked and flaked oilseeds are feed into the Expander in presence of co...
Last comment: December 20, 2016
(39) (0)
I was surprised when I saw the actual field reports under parallel trial taken on Mash Feed vs. Crumble Feed. It has been observed that everybody in the feed industry gives preference to Crumble/Pelle...
Last comment: December 1, 2016
(2997) (20)
Whenever raw materials are bought and stored, an assumption is usually made that the finished products produced will be of the same weight as the raw materials used during production. Ironically, this...
Last comment: November 30, 2016
(6) (0)
Last comment: November 26, 2016
(25321) (19)
Last comment: November 22, 2016
(353) (3)
Last comment: November 18, 2016
(29) (1)
Last comment: November 18, 2016
(2849) (3)
Last comment: November 16, 2016
(7155) (6)
   | 
Copyright © 1999-2017 Engormix - All Rights Reserved