This member gave a presentation on January 29, 2024
At the following event:
IPPE - International Production & Processing Expo 2024
Article published the June 1, 2023
IntroductionThe poultry industry aims to optimize the breast weight of the broilers because of its relatively higher market value. Through the years, improvements in breast meat yield have not only led to myopathies (Caldas-Cueva et al., 2021) but also to increased heat production (Martinez et al., 2019) due to the higher body protein content and turnover rates (Maharjan et al., 2020a; 2021b) in m ...
Article published the May 11, 2023
IntroductionOptimizing the breast size of broilers is a critical economic target due to its higher market value versus other cut-up pieces. Historical improvements in breast production have shown an impact on the efficiency of broilers in using dietary energy (Martinez et al., 2019a), which accounts for 70–75 % of the poultry feed cost. They have also been associated with quality conditions ...
Article published the March 10, 2023
IntroductionThe poultry industry aims to increase the breast weight of broilers due to its higher market price. However, the breast size is associated with meat conditions such as woody breast (Maharjan et al., 2021a), the body protein turnover (Maharjan et al., 2020a, Maharjan et al., 2021b) and lean mass weight (Martinez et al., 2020a), and changes in the partitioning of the dietary energy (Mart ...
Article published the August 2, 2022
INTRODUCTIONLarge variations exist in the literature on the recommended Ca and P dietary requirement for laying hens1. The Ca requirement was reduced from a previous suggested intake of 3.752 to 3.25 g h−1 day−1 by NRC3 after decades of consistently increasing the Ca intake requirement. The available P or non-phytate P (NPP) requirement for commercial layers was also reduced to 250 mg ...
This member gave a presentation on January 24, 2022
At the following event:
IPPE - International Production & Processing Expo 2022
Article published the February 1, 2021
This member gave a presentation on January 26, 2021
At the following event:
IPPE Marketplace - International Production & Processing Expo 2021
Article published the June 16, 2020
This member gave a presentation on January 28, 2020
At the following event:
IPPE - International Production & Processing Expo 2020