Participation in Forum on July 4, 2022
As far as alternative feed ingredients are concerned there are always possibility to establish new processing units from where byproducts can be utilized for cost and time effective supply of alternative feed ingredients. Hence, processing and value addition of crop produce need should be prioritized.
Participation in Forum on August 1, 2021
Any design which promote efficiency without compromising quality output would always be beneficial.
Participation in Forum on July 13, 2021
The research findings are one side of the technology however actual end users feedback matter for promise on other side. Hence feedback from end users are always the best results.
Participation in Forum on July 11, 2021
Crumble/Pellet definitely more productive with low FCR and less wastage.
Participation in Forum on July 9, 2021
Various feed ingredients based on their availability , cost of procurement and nutritional supplements can be traced from food , forest and pharma industries as their byproducts need to utilize if R&D on them permits
Participation in Forum on July 9, 2021
I agree with Er E. Diaz pellet feed is more productive and has less handling costs than mash
PRAKASH P. AMBALKAR likes this technical article:
A data-mining approach to help understanding key-technological parameters.Efficiency and productivity in the feed industry are rapidly increasing to meet a growing consumer demand in terms of safe and sustainable animal products. In this context, the feed industry has adopted the use of additives as an alternative solution to replace the use of antibiotics.Pre- and probiotics, as live yeast, are i ...
Participation in Forum on June 26, 2017
Participation in Forum on June 25, 2017
Sir,
I have produced good quality pellets without steam conditioning and results are encouraging however, I believe more techno commercial research is required from small and scattered farmer's view point.
With regrds,
PP Ambalkar
Participation in Forum on June 25, 2017
Dear Sir,
I mean wet pelleting with increased moisture percent and then use of dryer . As dryer is easy to handle and operate in comparison to steam generator? The process of production should be short and would also reduce manpower requirement at small farmer's level not at commercial level? May kindly comment.
With regds,
PP AMBALKAR