Explore
Communities in English
Advertise on Engormix

Managing Milk Composition: Maximizing Rumen Function

Published: January 1, 2002
By: Dan N. Waldner - Sandra R. Strokes - Ellen R. Jordan - Michael L. Looper
Various feeding management practices impact the levels of milk fat and protein concentration in raw milk. Feeding strategies that optimize rumen function also maximize milk production and milk component percentages and yield. There are several strategies that producers can use to enhance rumen function and the resulting milk components. Producers who use records, such as those provided by DHIA (Dairy Herd Improvement Association), can critically evaluate their nutrition and feeding management programs.

Feed Intake: Feed provides the nutrients that are the precursors, either directly or indirectly, of the principal milk solids. Thus, an increase in feed intake usually results in the production of a greater volume of milk. In general, the proportional increases in fat, protein, and lactose yields are approximately the same as the proportional increase in milk volume.

Managing Milk Composition: Maximizing Rumen Function - Image 1

Milk composition changes little.
It is critical to maximize feed intake of cattle so that negative energy balance is minimized during early lactation. As cows consume more energy than they use, body weight is regained, losses in body condition are minimized, and cows produce milk of normal fat and protein content. Increasing feed intake, and the resulting overall increase in energy, can increase milk protein content by 0.2 to 0.3 percent. High producing cows should eat 3.5 to 4.0 percent of their body weight daily as dry matter. If a herd is consuming less than this, production of solids-corrected milk may be limited.
Major factors that can affect feed intake include:
  • Feed bunk management (keep feed bunks clean, not empty)
  • Feeding frequency
  • Feed sequencing
  • Ration moisture between 25 and 50 percent (to optimize dry matter intake)
  • Social interactions and grouping strategy of the herd
  • Abrupt ration changes
  • Physical facilities
  • Environmental temperature.
Increased feeding frequency of low fiber, high grain diets increases milk fat levels. The greatest increase occurs in diets ofless than 45 percent forage and when grain is fed separately as in parlor feeding. When diets are fed as a total mixed ration, feeding frequency becomes less important as long as the feed remains palatable and is fed and mixed a minimum of once a day. During hot weather, more frequent feeding helps keep feed fresh and palatable.

Forage to Concentrate Ratio: On a DM (dry matter) basis, the minimum ratio of forage to concentrate required to maintain normal milk fat percentage is approximately 40-to-60. This ratio should serve only as a guide; other dietary factors influence the general effects that a decreased ratio has upon rumen fermentation. These effects include decreased rumen pH, increased propionic acid production and reduced fiber digestion. Obviously, type and physical form of ingredients that contribute to the forage or concentrate portion of this ratio must be considered.
Grain Feeding: The proper feeding of concentrates involves maintaining proper forage-to-concentrate ratios and nonfiber carbohydrate levels. Feeding appropriate nonfiber carbohydrate levels can improve both milk fat and protein levels, while overfeeding leads to milk fat depression of one unit or more and often increases milk protein percent by 0.2 to 0.3 units.
Nonfiber carbohydrates include starch, sugars, and pectin. The percentage of nonfiber carbohydrate is calculated as NFC = 100 - (% Protein + % NDF + % Fat + % Ash). Depending on the digestibility of the neutral detergent fiber (NDF) present, nonfiber carbohydrates should range from 34 to 40 percent of the total ration dry matter. In most instances, a nonfiber carbohydrate level between 36 to 38 percent is considered ideal. This level is typical of diets with less than 60 percent forage. Diets with greater than 60 percent forage may be deficient in nonfiber carbohydrates.

Managing Milk Composition: Maximizing Rumen Function - Image 2

When feeding for component changes, limit the amount of grain consumed during one feeding to 5 to 7 pounds to avoid rumen acidosis and off-feed problems that result in reduced fat content of milk. Grain feeding guidelines to maximize milk fat and protein production are provided in Table 1. Limit grain consumption to a maximum of 30 to 35 pounds per cow daily.
Manure containing large amounts of undigested corn or with a pH less than 6.0 can indicate too much grain or an imbalance of nonfiber carbohydrates in the diet. Fibrous byproducts such as soybean hulls can replace starchy grain and reduce the severity of milk fat depression in rations high in nonfiber carbohydrate.
Grain Processing: The type of grain and processing method can have a significant impact on the site and extent of starch digestion of a particular diet and resulting milk component composition and yield (Table 2). Generally, ground, rolled, heated, steam flaked, or pelletized grain increases starch digestibilities and propionic acid production in the rumen. Steam flaked corn or sorghum compared to steam rolled corn or dry rolled corn or sorghum consistently improves milk production and milk protein yield. In six comparisons, steam flaked corn increased milk protein percentage and yield and decreased milk fat percentage compared to steam rolled corn. Milk fat yield remained unchanged in these trials. Twenty-four (24) comparisons of dry rolled and steam flaked sorghum have produced similar results. These results are attributed to increased total tract starch digestibility, increased recycling of urea to the intestinal tract and increased microbial protein flow to the small intestine.

Managing Milk Composition: Maximizing Rumen Function - Image 3

Managing Milk Composition: Maximizing Rumen Function - Image 4

Extensive use of grains, such as wheat, that consist of a rapidly fermentable carbohydrate and overprocessing of grains can result in severe milk fat depression, off-feed problems and reduced milk yield. It is important to match carbohydrate and protein sources and to carefully monitor nonfiber carbohydrate levels in the diet to ensure proper fermentation patterns and to maximize milk component content and yield.
Ration Fiber Levels: The level of fiber feeding and the physical size of fiber particles contribute to the effectiveness of a fiber source for stimulating rumination (cud chewing), buffer production (salivation) and maintenance of normal milk fat and protein composition. Feeding of finely ground forages inadequately stimulates rumination and lowers saliva production.
The crude protein requirement for a 1,350-pound cow producing 3.6 percent milk fat ranges from 14.0 percent of total dry matter (TDM) for 50 pounds of milk to 18.0 percent TDM for 100 pounds of milk. Depending on the stage and level of production, the recommended level of undegradable protein ranges from 32 to 38 percent of crude protein. Keep soluble protein between 30 to 32 percent of crude protein, or about half of the degradable protein intake level.
It is essential to meet the cow’s requirement for both crude protein and rumen undegradable protein to avoid a negative impact on dry matter intake and fiber digestibility. Studies of diets containing no supplemental fat show that each 1 percent increase in dietary protein, within the range of 9 to 17 percent, results in a 0.02 percentage unit increase in milk protein. The additional synthesis of protein by mammary tissue likely is linked to limiting amino acids. Table 4 summarizes the various feeding management practices and their potential impact on milk fat and protein concentration.
Managing Milk Composition: Maximizing Rumen Function - Image 5
Related topics
Join to be able to comment.
Once you join Engormix, you will be able to participate in all content and forums.
* Required information
Would you like to discuss another topic? Create a new post to engage with experts in the community.
Create a post
Krishan Agarwal
4 de diciembre de 2010
a very good article on feeding to dairy animals .the author has well placed the importance of grain feeding thereby non fibre carbohydrates for increasing milk production at the same time keeping optimum level of crude protein and undegradable part of protein has been duly emphasized.thank u very much for enriching our knowledge.
Join Engormix and be part of the largest agribusiness social network in the world.
LoginRegister