Umer Hayat likes the comment:
Dear Amanda,I find it highly interesting that Shrimp feed can be done on your expander.It would be good to know what pellet sizes can be done and what would be the bulk densities that can be achieved with the corresponding water content in the expander.Thanks,Urs Wuest
Participation in Forum on October 3, 2018
Enrique Diaz
What is the minimum size we can get from this extruder while we producing shrimp feed?
Can you share me some video or photos from inner side that how to remove breaker bolts etc. We want to buy your extruder but truely we are little bit unsure about its operation does it user friendly or not. Because right now we are using a chinese company extruder, and facing problem as reassembli ...
Participation in Forum on October 3, 2018
Amanda Cresanto Do you think it would be easy to pull it out when material stuck into it and hard for some reason? Will it be pushed manually or by some hydraulic force?Also please tell me screws or worms are fixed on the shaft or replaceable?
Umer Hayat likes the comment:
I assume you are talking about roll shells for pellet mills.There are different configurations possible with roll shells.In general; Dimpled rolls have a better pressure distribution in the die but the gripping action is moderate.In general, the wear is more even in the die due to the fact that the product cannot escape to the side of the roll. Used for regular feed products with limited slippage ...
Participation in Forum on October 2, 2018
Amanda Cresanto Can we use this machine for shrimp and aqua feeds? Looks like screws/spirals of the extruder are inaccessible, so how you can clean the barrel when stuck/choked?Best regards,Umer Hayat
This member had joined Engormix
October 2, 2018